I also have no problems with output signal (my headphones is working fine through phones output on the front panel).However, in Komplete Audio 6 Control Panel I can see only No Komplete Audio 6 found.Reconnect the Komplete Audio 6, then open the Device Updater.
Also I tried to reboot my PC and I still see this message (picture below). Actually, I downloaded asio4all driver from and now I am able work with my current audio interface in Reaper but there is a high latency so I keep searching for better solution of the problem. KA6 is plugged in, and the Device Updater always says Please connect all your Native Instruments devices and restart the Device Updater, even after disconnecting and restarting the Device Updater. Since the computer recognizes the device as working, this isnt a driver problem. Komplete Audio 6 Control Panel Update The FirmwareYou can test this by trying to update the firmware on another computer. Please get in touch with us again if you run into another issue. Komplete Audio 6 Control Panel Software Is AccessibleAs Im a blind person, before eventually doing so I need to know whether you know if its control panel software is accessible to screen readers or not. I want to avoid buying something I wont be able use to its full potential. I have installed the driver on my computer, but without an actual unit its impossible to tell. All of the functions that were configured through the control panel for the MK1 hardware are now controlled by your DAWs audio configuration and the Windows system audio settings. I was under the impression that one at least needed the control software for changing the interfaces clock settings for the SPDIF input and output, but maybe that was the MK1. Komplete Audio 6 Control Panel Manual For SomeCould you, please, point me to the MK2 manual For some reason I cant find it anywhere. So, Im asking about the accessibility status of this application. From the little I have been able to inspect, I have found out that it utilizes a standard Windows tab control - so, so far so good, but unfortunately that doesnt guarantee that rest of the controls (that I cant see, because I dont have a NY device) are accessible as well. From what I have read, the Native Instruments Komplete Audio Control Panel is used for making a couple of advanced settings, such as changing the spdif digital clock source (having access to this is crucial, because its the main reason Im considering buying this interface). However, the buffer can also be set from your DAW and this will then be reflected in the Komplete Audio Control Panel. The Sample rate selected in your DAW will also be displayed from the Komplete Audio Kontrol Panel but cannot be set from the Control Panel. Im not sure if that is coming in a firmware and Control Panel update at some point, as this has not been mentioned so far. I get it now and I have already ordered a unit at one of the large retailers over here (Slovakia). I think that the answer is simple, but I think starting a new thread would be appropriate, so Ill do just that.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |